Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For any discussion not specifically related to your project
#50167
Hello men,
I have a board 0.4.4b that worked in a car with single chanel ignition output (distributor used) but now something on speeduino (arduino mega ignition signal works fine) doesnt work (looks like U2, tc4424a is burnt...).
Because i'm only using ignition chanel 1, maybe someone can help me how to swap on code ignition channel 1 to 4 that uses u4 TC4424A..

it would be great if someone who knows the code can tell me what to rename on code... or better if can send me a modified 2012 version

thank you very much
#50181
thanks to guide me to init.ino, i have modified this, i will try if this works.thanks

//Pin mappings as per the v0.4 shield
pinInjector1 = 8; //Output pin injector 1 is on
pinInjector2 = 9; //Output pin injector 2 is on
pinInjector3 = 10; //Output pin injector 3 is on
pinInjector4 = 11; //Output pin injector 4 is on
pinInjector5 = 12; //Output pin injector 5 is on
pinInjector6 = 50; //CAUTION: Uses the same as Coil 4 below.
pinCoil1 = 50; //Pin for coil 1
pinCoil2 = 38; //Pin for coil 2
pinCoil3 = 52; //Pin for coil 3
pinCoil4 = 40; //Pin for coil 4

I'm curious for the spec's here as well. Diesel[…]

You may find it interesting, that most racing te[…]

Whatever gets you what you're after. This is one […]

v0.4 Ca18det wiring

Thanks a lot for the info! I have read some on the[…]

Still can't find what you're looking for?