Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For any discussion not specifically related to your project
For a "look as stock as possible" engine, I have no easy way to fit a cam sensor.
Some BMW fuel injected Motronic versions had a very easy solution, as they where still distributor ignited. They used a ring shaped Bosch sensor that was put on the No. 1 cylinder ignition wire. This makes a very simple, discrete, inductive cam sensor (with distributor ignition only).
Has anyone used such a part on Speeduino or comparable installations?
I would use diode, resistor and Zehner array to get a near to square wave, 5V limited output signal.
Yes, and you can do a search for several examples here of inductive pickups and circuits. Some are based on DIY timing light pickups. Keep in-mind that certain wheel decoders that need cam signal to sync won't fire spark until it does, which means the cam signal never happens, so it never gets sync. Catch 22. :lol:

Hello, Looking for an ignition only control. Loo[…]

Debugging ignition ?

Read the wiki. www.speeduino.com

IAT and A0 with trimpot

Perhaps read the wiki?

bmw e36 m42 base tune.

But you got the files from somewhere? They will e[…]

Still can't find what you're looking for?