- Thu May 06, 2021 1:45 am
#50085
For a "look as stock as possible" engine, I have no easy way to fit a cam sensor.
Some BMW fuel injected Motronic versions had a very easy solution, as they where still distributor ignited. They used a ring shaped Bosch sensor that was put on the No. 1 cylinder ignition wire. This makes a very simple, discrete, inductive cam sensor (with distributor ignition only).
Has anyone used such a part on Speeduino or comparable installations?
I would use diode, resistor and Zehner array to get a near to square wave, 5V limited output signal.
Some BMW fuel injected Motronic versions had a very easy solution, as they where still distributor ignited. They used a ring shaped Bosch sensor that was put on the No. 1 cylinder ignition wire. This makes a very simple, discrete, inductive cam sensor (with distributor ignition only).
Has anyone used such a part on Speeduino or comparable installations?
I would use diode, resistor and Zehner array to get a near to square wave, 5V limited output signal.