- Tue Apr 20, 2021 10:01 am
#49713
Changing code pin assignment and uploading the firmware takes 30 seconds.
theonewithin wrote: ↑Tue Apr 20, 2021 10:01 am Changing code pin assignment and uploading the firmware takes 30 seconds.I would prefer not to change the firmware because if I start doing that I will always have to do it at every update ,I will leave that as a last resort.
theonewithin wrote: ↑Thu Apr 22, 2021 8:20 am I wouldn't be surprised if this issue is fixed next release...EH......I've been tuning for many years 16x16 tables do not worry me, glitches do worry me though... I would not like my fuel pump output to drop out randomly ,would you? I DO NOT THINK that having to mod the firmware every time I update is very smart...or did you mean change it now just to see if it works?
And it's changing the number on 1 line...
If that's to hard you won't like having to tune a 16x16 table.
jackscr wrote: ↑Thu Apr 22, 2021 7:57 pmChanging the digit of 2 lines of code is far from "modding" firmware...theonewithin wrote: ↑Thu Apr 22, 2021 8:20 am I wouldn't be surprised if this issue is fixed next release...EH......I've been tuning for many years 16x16 tables do not worry me, glitches do worry me though... I would not like my fuel pump output to drop out randomly ,would you? I DO NOT THINK that having to mod the firmware every time I update is very smart...or did you mean change it now just to see if it works?
And it's changing the number on 1 line...
If that's to hard you won't like having to tune a 16x16 table.
I swapped the wires from the shift light to the timer and it's even worse, so the fan output is not at fault... Everything works except when the output needs to stay on permanently...
I will change it in the firmware next and see if it works that way...at least rule everything out...
nice first of all, i read all that crap months a[…]
I rewired a few grounds and tested the TPS and rel[…]
Thanks, car runs great now !!! Going to drift even[…]
Still can't find what you're looking for?