Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For discussion of Speeduino compatible boards designed / built by other members of the forum and for guidance around making such a board
#46825
help my voltage sensor floats like crazy beetween 2 to 5 volts regardless the input voltage.
when im going to test outpouts with hardware test from speeduino injecor chaneli have led on 2 3 injector and hc 1 2
i need to changhe pin on speeduino compiles.choosed dvjcodec ecuteen b please helppp
#47242
subzero wrote:
Tue Dec 22, 2020 8:55 am
//Note: This must come after the call to setPinMapping() or else pins 29 and 30 will become unusable as outputs. Workaround for: https://github.com/tonton81/FlexCAN_T4/issues/14
#if defined(CORE_TEENSY35)
Can0.setRX(3);
Can0.setTX(4);
#endif
We are aware of this issue as it was submitted by one of OUR members (@ben , on slack)
#48167
/Note: This must come after the call to setPinMapping() or else pins 29 and 30 will become unusable as outputs. Workaround for: https://github.com/tonton81/FlexCAN_T4/issues/14
#if defined(CORE_TEENSY35)
Can0.setRX();
Can0.setTX();
#endif
when uy compile like this ,can pins reset to pins 3 , 4 and all works flawessly,another think with speeduino 3.7 and 440cc injectors all works ok with scg ecu with same settings afr is 9.6 rich and dead times goes from 1.2 to 0.8 ? strange
#49747
Hello friends.
I assembled my SCG-ECU 1.0 board. I also made arrangements related to the software. My tests are running smoothly in TunerStudio program. But in the 202103 version, 2.4 volts are continuously coming from the 31 pin of my Teensy 3.5 board to IGN3. This problem does not happen in the 20208 version, but 2.4 volts is coming to IGN3. Anyone have a suggestion for this?
Inkedign3_LI.jpg
Inkedign3_LI.jpg (3.23 MiB) Viewed 272 times
  • 1
  • 19
  • 20
  • 21
  • 22
  • 23
M43B18 injector wiring

In your case, why don´t you just exchange […]

Teensy based mainboard

OpelPanFan have a board who work with 3.6 on easye[…]

Hi I just finished connecting my Speeduino 0.4.4c […]

Decoders - What do you want to see?

Pretty sure it is supported already. You just use[…]

Still can't find what you're looking for?