Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For any discussion not specifically related to your project
User avatar
By riky
Guys i can't figure out how to connect 0261210104 crank sensor from fiat punto gt. The issue is that i can't find any proper manual and get sensor working. I don't know if my jumpers are set correctly. On megasquirt forum i found that guy only wired signal and ground wire to connector.

How should i wire that connector, i tried many ways but nothing is not working. What i do wrong!?
IMG_20210422_175113.jpg (6.03 MiB) Viewed 397 times
IMG_20210422_175052.jpg (7.17 MiB) Viewed 397 times
If this is a VR sensor and you have connected it without a conditioner you may have damaged your Arduino.

Hope you have a spare.

There are ways to figure out if you have either sensor but you generally check this first before connecting it so you don't cause damage.

And that part number is 100% a VR sensor not a Hall sensor.
How should i set my pull up jumpers then if it's VR sensor?
Here is my base tune if somebody can check it please?

Do i need to set 5v or 12v then with jumpers

So if i get right i need to connect
1 pin on VR1+
2 pin on VR1 -
3 pin on GND
(73.5 KiB) Downloaded 11 times
Suzuki alto pocket rocket

hard to tune without one, bosch lsu 4.9 is the one[…]

Nissan 360 trigger type 1 from the wiki, for Nissa[…]

Does a 22RE board already exist???

Well my initial plan of attack is a prototyping an[…]

issue found, faulty speeduino board or component. […]

Still can't find what you're looking for?