Help with building your Speeduino, installing it, getting it to run etc.
#50111
How i can see with tunerstudio the signal from cam sensor ? Because when i am looking the composite logger when cranking i see the signal from crank sensor in blue color , the red line from sync but that green from the cam signal doesnt appear at all. And so on i dont have a spark either...
#50119
theonewithin wrote: Thu May 06, 2021 9:35 pm Do you have a can sensor connected that is support?

You haven't posted your tune or a log either. Both are needed to see what is happening.

Also have you read the wiki to get an understanding of what signals the ECU requires to run?
Give me mail address or messenger to post some pictures of the project , because here is a little hard to me to send to you

Will this have an updated version about this featu[…]

See my earlier post . The Base Tune sets t[…]

Vr Conditioner Noise when cranking

I did the fix, but it's not work. I put my setti[…]

Perhaps some different points and pictures. Instr[…]

Still can't find what you're looking for?