- Sun Apr 18, 2021 6:24 am
#49684
everything is from digikey except arduino mega, which is cheaper ebay version. could it be the problem?
assane wrote: ↑Wed Apr 28, 2021 5:29 pm I'm having problems with Bluetooth. If there is a diode on d1, it does not read, but when I remove it and give a jumper, bluetooth works. Can you make a jumper on d1 instead of the diode? I have 3 mega 2560 clones and each has the same problem.What pcb version? The d1 silk screen was wrong way around in some point. The purpose of that diode is to allow use of usb in addition to bluetooth connection. You can jumper over it, but then usb will not work unless you unplug bluetooth dongle.
pazi88 wrote: ↑Wed Apr 28, 2021 7:38 pmpcb rev2.2 jlcpcb, parts from digikey.assane wrote: ↑Wed Apr 28, 2021 5:29 pm I'm having problems with Bluetooth. If there is a diode on d1, it does not read, but when I remove it and give a jumper, bluetooth works. Can you make a jumper on d1 instead of the diode? I have 3 mega 2560 clones and each has the same problem.What pcb version? The d1 silk screen was wrong way around in some point. The purpose of that diode is to allow use of usb in addition to bluetooth connection. You can jumper over it, but then usb will not work unless you unplug bluetooth dongle.
JRockland wrote: ↑Fri Apr 30, 2021 5:05 pm Hey ! new guy here.You will require a board that support 8x8 that uses either the STM32 or Teensy for what you want.
Currently working on a M73 projects and I just found out about the Speeduino.
That board (v0.3) wouldn't work for me until I saw your post: your board can do full sequential 6 cylinders ?
So to be clear you have 6 output for injector and ignition ? If it is the case I would love to give it a try on my engine running half sequential as mine have 12 cylinders...
Please confirm about the 6 outputs, in the mean time I will be reading a bit more about the project.
Also as most of the sensors and problems will be the same between our projects I will probably have a thousand question..
**Just to specify I'm not retarded, Just French.. so sorry for my writing.
I uploaded logs and last tune and dyno plots look[…]
Still can't find what you're looking for?