- Sun Mar 21, 2021 12:37 pm
#49190
Hi guys!!!
I have a problem with my e36 4 cylinder M43B18 engine.
I took an original 88 pin connector to keep my car's electrical system intact.
The problem is that in the manual the injectors are connected together like this 1-3 and 2-4.
The firing order is 1,3,4,2.
From what I understand if on the studio tuner I set the "paired" method with the stock wiring I will have the injection sequence 1-2,3-4.
INJ OUT 1 -> INJ 1-3
INJ OUT 2 -> INJ 2-4
It doesn't seem to me the most appropriate sequence.
If there was a way to change the activation order of the injectors from Arduino I would have solved the problem for example:
1-1-2-2
instead of:
1-2-1-2.
I'm not a computer scientist so I don't know where to go to change the firmware.
I hope I have explained the concept clearly.
Thank you.
I have a problem with my e36 4 cylinder M43B18 engine.
I took an original 88 pin connector to keep my car's electrical system intact.
The problem is that in the manual the injectors are connected together like this 1-3 and 2-4.
The firing order is 1,3,4,2.
From what I understand if on the studio tuner I set the "paired" method with the stock wiring I will have the injection sequence 1-2,3-4.
INJ OUT 1 -> INJ 1-3
INJ OUT 2 -> INJ 2-4
It doesn't seem to me the most appropriate sequence.
If there was a way to change the activation order of the injectors from Arduino I would have solved the problem for example:
1-1-2-2
instead of:
1-2-1-2.
I'm not a computer scientist so I don't know where to go to change the firmware.
I hope I have explained the concept clearly.
Thank you.