Engine is running R6 ITBs and VW coil pack, things are progressing.
TPS CLT all hooked up and correct data.
36-1 trigger wheel on crank with VR and I have a nice signal and timed up using the fixed timing etc... so the trigger angle is all correct and firing the coil pack (wasted spark) and even runs a bit when you some fuel down its throat so all good so far.
Now the questions is regarding the injection side. The injectors are high Z (11.2 ohms) Ideally I would like to run without a cam sensor, so is the only option to run the injectors paired? or can I run semi sequential with crank only trigger?
and in Tuner Studio I have the Trigger Settings as missing tooth but at the bottom of the settings it wants the secondary trigger settings which dont have. so is it case of I need to run a cam trigger and if so at what point before TDC on number 1 is the trigger needed.