- Fri Feb 26, 2021 11:31 pm
#48636
Ok. Next question for someone who has done some simulation.
I will need to do some testing of the Mega and Speeduino board to test the IAC control.
Is it as simple as getting another Arduino board, rite some code to output a 5v signal to replicate the trigger (12-1 in my case) , set the input from VR (current config) -> Hall on the jumpers. Join the earths (0 volts) and send it.
Will that be enough to make the speeduino think it is running and start to output some IAC signals. Then I can trace the signals with my volt meter.
Cheers StuM
I will need to do some testing of the Mega and Speeduino board to test the IAC control.
Is it as simple as getting another Arduino board, rite some code to output a 5v signal to replicate the trigger (12-1 in my case) , set the input from VR (current config) -> Hall on the jumpers. Join the earths (0 volts) and send it.
Will that be enough to make the speeduino think it is running and start to output some IAC signals. Then I can trace the signals with my volt meter.
Cheers StuM