- Sat Dec 26, 2020 4:02 pm
#47293
I have obviously been a good boy this year and now have a new V4 Speeduino and a Speedy sim.
Any way there are absolutely no instructions on firmware or wiring with the kit so I started digging around the forum and web.
There is one reference I can find showing where to find a Serial UI library which I have loaded and another for the code to run the speedysim (its the one from DIY-EFI with the Nano on board).
Anyway when I load the code in the Arduino IDE it give lots of errors (item not declared in scope etc.) and wont load.
So my questions are;
Is there a latest set of library and firmware codes?
Is there any form of user instruction for the software?
Is there any wiring info?
Apologies if I have missed this all somewhere in the forum.
Thanks....
Any way there are absolutely no instructions on firmware or wiring with the kit so I started digging around the forum and web.
There is one reference I can find showing where to find a Serial UI library which I have loaded and another for the code to run the speedysim (its the one from DIY-EFI with the Nano on board).
Anyway when I load the code in the Arduino IDE it give lots of errors (item not declared in scope etc.) and wont load.
So my questions are;
Is there a latest set of library and firmware codes?
Is there any form of user instruction for the software?
Is there any wiring info?
Apologies if I have missed this all somewhere in the forum.
Thanks....