In some way, the Speeduino is not sending the signal to D5. Where to look next, where are the pins assigned? Some .ini file somewhere? I have no clue, I used SpeedyLoader to get the firmware on.
+1. This rarely happens (usually old sketch junk left behind), but if you suspect it:
That sketch is in your Arduino IDE, and ensures all of your EEPROM is wiped clean before loading new or upgraded code.… If test results are poor, you have a Mega or code issue. Load and run EEPROM_Clear, then reload code. Try calibration and testing again. …
That was fast! I really didn't expect so many answ[…]
Hi all, Michael, Sorry for the delay, not easy to[…]
Also to add that there are no missing items there […]
Well 1 big issue with reading radiator coolant tem[…]