Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For any discussion not specifically related to your project
By joey120373
#46747
Quick question, I putting together a board for JLPCBs Assembly service. Just want to try it out. And, though I think it’s an error, all of a sudden their stock of ATMega2560s went from a whole bunch down to 1 in stock. So that means my board won’t get populated.

They have plenty on the ATmega1280s with the same footprint. So I was wondering if the current code will load and run on the 1280?

Thanks
Rev counter question

EDIT: I think I created a bit of confusion (in[…]

On most of the stock engines I've worked on the sc[…]

Dont be put off :) Soldering is about quality sol[…]

Kawasaki Concours 2.0

Been a bum of the last two weeks. Had to have a co[…]

Still can't find what you're looking for?