[Gregtsi88]

Having issues getting crank signal we are running a ua4c using a 98 ford escort crank sensor i have the air gap at about 25k No sinc what so ever through tuner studio. But then my buddy touched the vr board by accident and we had sync for a second. And we do have the jp2 going in direct with no pull up resistor

[hotrodandy]

Ok so we swapped it over to a hall effect sensor, one from diy auto tune that I had "the black one". I changed the jumper jp2 to direct. When I use my scope it shows a nice square wave when I hook it up to rpm1+ my signal goes away. Any ideas?

[Gregtsi88]

Strange enough now if we touch the bottom of the board between the jp2 and jp3 jumpers and the vr conditioner board it sincs right up