Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For any discussion not specifically related to your project
By Gregtsi88
#46657
Having issues getting crank signal we are running a ua4c using a 98 ford escort crank sensor i have the air gap at about 25k No sinc what so ever through tuner studio. But then my buddy touched the vr board by accident and we had sync for a second. And we do have the jp2 going in direct with no pull up resistor
By hotrodandy
#46658
Ok so we swapped it over to a hall effect sensor, one from diy auto tune that I had "the black one". I changed the jumper jp2 to direct. When I use my scope it shows a nice square wave when I hook it up to rpm1+ my signal goes away. Any ideas?
VVT Driver/Control Circuit

If you find this complicated, start installing an […]

Just something personal: I´m extremely anal […]

0.4.4c ignition channel failure (?)

Just do an eeprom clear, load the firmware and th[…]

Australian Delivered Honda D16y4

If you want this semi sequential process, you need[…]

Still can't find what you're looking for?