For any discussion not specifically related to your project
By shirtz
#46018
hi guys, i hope this is an easy one. sorry im a newb and i have searched.

i have the above in a mx5 and it wont get any power unless connected to my laptop - doesn't even have to be connected to tuner studio.

i asked the question on FB and lots of comments re dud voltage regulator and "LM7805". im looking at the ECU and i cant find LM7805 no matter how hard i squint! any help with locating it?

i note there is away to bypass it. is there anything else i should look at first? my soldering skills are very bad so id happily pay someone to do it for me if anyone is keen!
#46025
Ok, you can't bypass the 5v regulator, it must have a decent 5v supply!
You won't find an lm7805 as we don't use those! We use the low droput version the lm2940..

On the na6 I believe the mc33814 provides the 5v rail which is not something a novice should attempt to remove

If your soldering skills are that bad , pay someone to fix it. Email one of the suppliers a few do offer repair services.

See the snap shots of the PSU section of a na6 below and the vo4 that uses a LM reg
Attachments
Screenshot_20201024-075613.png
Screenshot_20201024-075613.png (196.27 KiB) Viewed 2604 times
Screenshot_20201024-075757.png
Screenshot_20201024-075757.png (191.45 KiB) Viewed 2604 times

Hi, I am trying to assign Signed values to the x-a[…]

Vr Conditioner Noise when cranking

New version 202305 don't fix the issue. Now after[…]

blitzbox

I've finally figured out why MAP and Lambda weren'[…]

Hello, I bring news!! Let me tell you that after […]

Still can't find what you're looking for?