Help with building your Speeduino, installing it, getting it to run etc.
User avatar
By Eric H
#45390
The Iridium plugs are NGK BKR6EIX

Got back from the dyno today. The car ran great.
We made 151 whp and 174 ft lbs of torque. On a 2l 8V motor at 8-9 psi boost with a low-reading dyno.
It's got a big fat torque curve from 3k-6k. We should have fantastic dig out of the corners now.
User avatar
By Eric H
#45988
A further followup.
We had our only race of the year at the beginning of the month.
The engine had significant blow by issues from the moment we unloaded it off the trailer, we must have damaged a ring while tuning. When we tear it down we'll know for sure.
After driving for a bit we started having misfires so I pulled the plugs and checked them, and they looked fine.
I swapped in the iridium plugs as a test and the car ran much better. ¯\_(ツ)_/¯

After a short while on the track we had a catastrophic wheel bearing failure that snapped the axle and let the wheel escape. :oops:
It broke the brake caliper bracket on its way out and since it's rare and we had no spares our race was over. :evil:

Here's some in car video from the race: https://www.youtube.com/watch?v=SCmnJtaC9RY

It looks like you have a fuel supply issue. readin[…]

Will this have an updated version about this featu[…]

Vr Conditioner Noise when cranking

I did the fix, but it's not work. I put my setti[…]

Perhaps some different points and pictures. Instr[…]

Still can't find what you're looking for?