Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For anything you'd like to see added to Speeduino
By andymcg
#24982
Has there been any progression on this? I am looking to use speeduino for my k series. is it possible to run using standard sensor and flywheel rather than fitting a 36-1 wheel? I have the 0.4.3 board with vr conditioner
By dazq
#24983
Not heard anything :-( perhaps you could put in another request on git for the feature!
By Dziku
#45712
Any progres? Is it posible to run vvc with vvt output? Theoreticaly it should work if we add cam trigger, and know the specs of the valve...
By miker
#45737
I'm going to have a watch of the video on making trigger patters again. If it makes sense I may have a play.
By dazq
#45739
Have a search on the Facebook group.
Someone did write a working mems decoder a while back but never submitted a pr for it via GitHub.
It may save some time rather than starting from scratch.
By miker
#46088
I've started working on this. Just working on getting the trigger wheel working (not cam) initially.

In theory i think i can get both the 1.9 and 2.0 mems working on the same speeduino trigger pattern which should be nice.
Trigger on Pick-up/Ignition

Use a coil trigger to feed RPM info to Speeduino. […]

Volvo 940 Turbo

So I have been thinking and testing some stuff out[…]

Water pump controller via boost port

That isn't supported in Speeduino. You will need […]

Board choice is very much a personal one although […]

Still can't find what you're looking for?