- Tue Oct 06, 2020 6:55 pm
#45692
Hi, I am going to be starting a boosted vortec 4200 build that had a GM 7X wheel on it.
I would like to run sequential on it as I am going to add a individual EGT sensor per runner to trim each cylinder.
Looking online a bit it looks like the 4200 has been attempted before, but the trigger setting were not working correctly?
Also looking at the code, there is nothing for the secondary trigger input, which I would need to get a 720 degree trigger.
Should I continue down the path of using the stock trigger setup or would it make more sense to just switch to a different custom wheel?
I would like to run sequential on it as I am going to add a individual EGT sensor per runner to trim each cylinder.
Looking online a bit it looks like the 4200 has been attempted before, but the trigger setting were not working correctly?
Also looking at the code, there is nothing for the secondary trigger input, which I would need to get a 720 degree trigger.
Should I continue down the path of using the stock trigger setup or would it make more sense to just switch to a different custom wheel?