Any strange behaviour, crashing issues etc, post them here! Problems compiling the firmware should go in the General support section rather than here
By Knack
#45407
I was running 202005 and the fuel pump priming worked fine. Now that I have updated to 202008 it only primes the pump for about 0.5 second if at all. But the engine will still start and run just fine. i have tried changing the time to 3, 4 and 6 seconds, with no change.

Anybody else see this?
By theonewithin
#45411
Check through ALL settings.

A lot changed in the latest firmware.

You may need to start fresh and load Speeduino base tune first then load your tune over the top and check everything again.

I uploaded logs and last tune and dyno plots look[…]

you could set 'skip revolutions' to 3, then it wou[…]

Hi, I am trying to assign Signed values to the x-a[…]

blitzbox

I've finally figured out why MAP and Lambda weren'[…]

Still can't find what you're looking for?