Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
Any strange behaviour, crashing issues etc, post them here! Problems compiling the firmware should go in the General support section rather than here
By runis6
#45395
Hello! So i guess from newest update have some issue with RPM limiters. Is not working Launch Control at all, and is not working Engine Protection RPM. So in the TunerStudio the LaunchHard warning is showing when it needed to be activated but the Arduino is doing nothing. I think some problem is in speeduino.ini file, some mistake or something. I also added video below... Also add the tune file. Thanks!

https://youtu.be/ExXaAjBuqxQ

Reinis!
Attachments
(70.63 KiB) Downloaded 17 times
Water pump controller via boost port

Simplest option would be a separate controller tha[…]

ATmega2560 vs ATMega1280

Unlikely... It has half the flash space as the 25[…]

Question about sensor groud

There is only 1 ground in Speeduino designs genera[…]

Idle control valve pin question

Sorry it's hard to understand what your actual iss[…]

Still can't find what you're looking for?