- Mon Sep 17, 2018 4:06 pm
#28941
I've been driving round with the risk of connection loss and a stall, so would like to get reset control working. I decided to just go for the serial command option initially, and have duly connected pin 51 to the reset pin using a wire on the underside of the Arduino. I've selected pin 51 in the settings in TS of course.
However, this seems to make no difference. If I just switch on the ignition, I hear the fuel pump prime as normal and then if I connect the USB cable it re-primes again so is obviously still resetting. It doesn't reset if I pull the cable, but it does if I plug it in again.
I can see that pin 51 is being held high if I measure it with my DVM.
I dunno what I've done wrong?
However, this seems to make no difference. If I just switch on the ignition, I hear the fuel pump prime as normal and then if I connect the USB cable it re-primes again so is obviously still resetting. It doesn't reset if I pull the cable, but it does if I plug it in again.
I can see that pin 51 is being held high if I measure it with my DVM.
I dunno what I've done wrong?