For any discussion not specifically related to your project
By der_vierte
#44097
d0nny94 wrote:
Tue Jun 18, 2019 7:59 pm
LPG2CV wrote:
Tue Jun 18, 2019 7:40 pm
@D0nny94

As for the tachometer.

If you do need a tacho out.
The 1.6 does not take a tacho feed from the ECU so in v1.0 there is no
provision for that.

Firstly does the tacho not work at all as it is now, as on some 1994
cars the tacho pin on the ECU is actually an input from the coil pack
as feedback.
It can be seen on one of the diagrams here.
https://rusefi.com/wiki/index.php?title ... Miata_1994


It does require a small internal modification and adding of a
resistor.
You need to run a small wire from the pad labelled LS1 on the board to
pin you want to use for tach out.
You'll also nee to add a 1k resistor between that chosen pin and 12v.
Then set the tacho out pin to 49.
I can provide pictures if needed.

Pictures please :D Maybe I'm dumb, but I stared at it for a minute, but couldn't find "LS1".
Can someone mark it, please? I'm a total noob with these things.
proyect ford zetec-e 2.0 16v

Wow! Awesome. Thank you

I have moved my design files to the more logical p[…]

If you have max coil primary voltage at 400V : -[…]

Problems loosing sync

normally it should be ok, but the output from anot[…]

Still can't find what you're looking for?