- Sat May 30, 2020 1:47 pm
#43262
I slapped the newly soldered board onto the Arduino, loaded the firmware, and am connected through Tuner Studio. I don't have any sensors hooked up to it except for MAP, although I think I cooked the MAP while soldering it in. My Tuner Studio gauge reads 3 PSI and it doesn't change when I blow into it.
On the board itself, the LED7 LED is on but everything else is off.
How do I know if I put this thing together correctly before moving on? Or do I just wire sensors up to it and see if it works?
This is going in my old muscle car for reading temperature and stuff for the time being. Eventually fuel/spark control but treating it as a data logger for now.
Are there any lights that should or shouldn't be on when only plugged into the computer?
Thanks!
On the board itself, the LED7 LED is on but everything else is off.
How do I know if I put this thing together correctly before moving on? Or do I just wire sensors up to it and see if it works?
This is going in my old muscle car for reading temperature and stuff for the time being. Eventually fuel/spark control but treating it as a data logger for now.
Are there any lights that should or shouldn't be on when only plugged into the computer?
Thanks!