- Wed Apr 08, 2020 1:24 pm
#41942
i've read again the wiki, and not sure which hardwares support canbus and which version. is it only mega and std v1.0?
choyr wrote: ↑Wed Apr 08, 2020 1:24 pm i've read again the wiki, and not sure which hardwares support canbus and which version. is it only mega and std v1.0?Yes use a mega MCU and the gpio std firmware.
The can is implemented using mcp2515 interface boards. Pin settings can be seen in the firmware, you can move cs and int pins if needed, but the hardware spi pins must be otherwise used.
- By CAnAm
- By pazi88