Firmware live stream happening this weekend: viewtopic.php?f=13&p=43195
Anything not specifically related to the Speeduino hardware. Eg sensors, bluetooth, displays etc
#41943
choyr wrote:
Wed Apr 08, 2020 1:24 pm
i've read again the wiki, and not sure which hardwares support canbus and which version. is it only mega and std v1.0?
Yes use a mega MCU and the gpio std firmware.
The can is implemented using mcp2515 interface boards. Pin settings can be seen in the firmware, you can move cs and int pins if needed, but the hardware spi pins must be otherwise used.
PCB for BMW m52 engine

Hi Pazi. Please tell me how to use VW red ignitio[…]

NA VVT Swap No Start

Relevant manual page: https://wiki.speeduino.com[…]

E190 2.3 8V FUEL ONLY

I think there is a reason why OEM bosch costs 70$ […]

May 2020 firmware release

I could try the 680 ohm, but the onboard pullup […]

Still can't find what you're looking for?