For any add-on boards such as VR conditioners, optos and OEM interface boards
#43002
Hi. Does esp32 have enought I/O to be used for transmission control.
I want to have it in combination with stm32 for speeduino engine control.

Esp32 is pretty cheap and powerfull, and i have few layng around.. but they have limited I/O..
#43003
Gouster4 wrote: Thu May 21, 2020 3:42 pm Hi. Does esp32 have enought I/O to be used for transmission control.
I want to have it in combination with stm32 for speeduino engine control.

Esp32 is pretty cheap and powerfull, and i have few layng around.. but they have limited I/O..
You could compare the needed inputs for the transmission that you would like to control with the available I/O on the ESP32. If there is ample I/O, the program would likely need some changes. This appears to be a lot of work to reinvent the wheel.
By dazq
#43004
Gouster4 wrote: Thu May 21, 2020 3:42 pm Hi. Does esp32 have enought I/O to be used for transmission control.
I want to have it in combination with stm32 for speeduino engine control.

Esp32 is pretty cheap and powerfull, and i have few layng around.. but they have limited I/O..
I don't have any plans on using an esp32 for the firmware used here , the mega onboard MCU has plenty of ability for now , I may update to use a samd21/54 in the future .
  • 1
  • 10
  • 11
  • 12
  • 13
  • 14

It looks like you have a fuel supply issue. readin[…]

Will this have an updated version about this featu[…]

Vr Conditioner Noise when cranking

I did the fix, but it's not work. I put my setti[…]

Perhaps some different points and pictures. Instr[…]

Still can't find what you're looking for?