Firmware live stream happening this weekend: viewtopic.php?f=13&p=43195
Help with building your Speeduino, installing it, getting it to run etc.
By Luke J
Hi everyone, I'm building a bench test kit for my uni project similar to the one in this link Everything is good so far but I'm at the stage where he plugs in the ignition led light to ground an ignition channel to check the timing of the ignition. However, the led doesn't flash when connected. The ignition leds on the board flash as expected. I'm using a 5v led from rs components.
Board is 0.4.3
4 stroke engine
By Luke J
Forgot to add that the speedy is only powered by the USB from my laptop, do I need to add the power for the arduino plug or the 12v directly on the speeduino to make it work?
Startup Jaguar V12

This stall issue when computer is disconnected, is[…]

May 2020 firmware release

No sir, the eth pin is unassigned :). I could try[…]

analog inputs floating ?

I would recommend against using the on chip resist[…]

Quite a few people seemed interested, so this week[…]

Still can't find what you're looking for?