New wiki and manual has launched! Check it out at http://wiki.speeduino.com
For discussion of Speeduino compatible boards designed / built by other members of the forum and for guidance around making such a board
By Hasse.69
#41731
Any progress on this one?
It's realy interesting.
By Dagaz_Psi
#41747
Yeah it works, have two cars running on it at the moment.
The two problems i have had is that the main relay wont get activaited the way I tought, so i hade to move it to the ac on pin and use a 2n2222 and a 7.5k ohm resistor to 12v.
The other is that I get power the backway from were I put the extra injector outputs. Because there are diffrent versions of the harnesses depening on model and years.
But the ecu connector is realy easy to depin and repin.
By Hasse.69
#41752
Would it be possible to buy PCB,s from you to SPEEDUINO my 944FTT?
By Dagaz_Psi
#41932
Some updates on the project.
Have redesigned the pcb for the fuelbox to make it more PNP, when I get the new boards and test them out I will post the easyeda link here.
Im in the midle of redesing the ignitonbox pcb, with better voltage protection, filtering and a op amp connected to the knocksensor and a headphone jack.
Is there any way to logg the sound in tunerstudio or sync up logged sound with runerstudio?

Dazq. Thank you for a quick reply. You are the […]

i've read again the wiki, and not sure which ha[…]

Printing in PETG. PLA wouldn't stand a chance in[…]

Thanks for the positive feedback. I'll stick with […]

Still can't find what you're looking for?