- Fri Feb 14, 2020 5:57 pm
#40943
Hello Everyone. First of Great job on this software. I've downloaded the source code for the firmware and have been looking through it and playing with it a bit on a bench setup. (ordered a couple speeduino boards to play with too) Anyway, very impressed with the work done here. And impressed with the people on this forum. Hope that at some point I can contribute to the work in some way.
About me. My son and I have done quite a bit with cars and Arduino's over the last 8 or so years. Typical kind of things, ipod to car integrations, cam and crank pulse simulators, EEPROM chip readers etc. But most of our time was spent with CAN bus. If there is any help that I could do there let me know.
Anyway my question, and sorry if I'm asking in the wrong place, is in regards to A/C request and control. My brother is using a speeduino on his Miata. And he asked if I could look at some issues he was having with triggering the A/C and getting the idle up to all happen at the right times etc. It appears to me a small A/C controller as part of the speeduino code would work well. I found some code posted sometime in the looked to be an A/C control section but I don't see anything in the released code (perhaps it was just suggested code). Before I go trying to add in some custom code for him thought I'd ask if I'm missing something in regards to the best way to do A/C control.
Thanks for any tips you can provide.
Thaniel
About me. My son and I have done quite a bit with cars and Arduino's over the last 8 or so years. Typical kind of things, ipod to car integrations, cam and crank pulse simulators, EEPROM chip readers etc. But most of our time was spent with CAN bus. If there is any help that I could do there let me know.
Anyway my question, and sorry if I'm asking in the wrong place, is in regards to A/C request and control. My brother is using a speeduino on his Miata. And he asked if I could look at some issues he was having with triggering the A/C and getting the idle up to all happen at the right times etc. It appears to me a small A/C controller as part of the speeduino code would work well. I found some code posted sometime in the looked to be an A/C control section but I don't see anything in the released code (perhaps it was just suggested code). Before I go trying to add in some custom code for him thought I'd ask if I'm missing something in regards to the best way to do A/C control.
Thanks for any tips you can provide.
Thaniel