- Thu Feb 06, 2020 3:14 pm
#40775
Can a GM 7/8 pin module correct a vr sensor signal or would I still need a vr conditioner to get a usable signal to the speeduino board?
vandea05 wrote: ↑Thu Feb 13, 2020 9:34 am Hi David, I'm curious why the Speeduino needs a 5v pullup if the 7/8 pin module puts out a 5v square wave? What am I missing?In many cases, the output from sensor is just grounded when tooth is seen, so 5v pull up pulls the voltage to 5v when output is not grounded, leading to 5v square wave. Not familiar with GM stuff, if that's the case, but still.
vandea05 wrote: ↑Thu Feb 13, 2020 9:34 am Hi David, I'm curious why the Speeduino needs a 5v pullup if the 7/8 pin module puts out a 5v square wave? What am I missing?That depends on if you are using terminal C or R. C is always safe, as the pullup voltage is from Speeduino. R may be safe, but you need to test the voltage it outputs at all reasonable supply voltages in order to ensure it remains below 5V (5.5V absolute max), or you can fry the processor input. Some have tested at closer to 6V.
Had it running for a short period again. Same as […]
Ok, here is the first version of the adapter plate[…]
Yes, totally wrong setting. Slight noise in TPS ca[…]
Still can't find what you're looking for?