Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For anything not related to Speeduino, but still about car/bike/boat/engines etc
By JHolland
Check the supply voltages are present using the programmer software. Is the board powered or are you trying to power it through the PICKit3?
User avatar
By Bleeker
I tried programming in circuit and also on a bread board.
Played around with all different kinds of settings, but nothing helped.

In the Video above the guy says it should show serial no. “default_pk3” for PICkit clones, but in my case it actually shows a serial no. not sure if this makes a difference.

I spend a lot of time googling this issue and it seems like the PICkit3 causes much more issues than the Version 2 but I found no solution for my problem.

When I measure the voltage directly on the PIC, should it always show some voltage when the PICkit is connected or just during programming?

Currently I´m thinking about buying a PICkit2 or just stop wasting my time and scrap that stuff ;)
Trigger on Pick-up/Ignition

Use a coil trigger to feed RPM info to Speeduino. […]

Volvo 940 Turbo

So I have been thinking and testing some stuff out[…]

Water pump controller via boost port

That isn't supported in Speeduino. You will need […]

Board choice is very much a personal one although […]

Still can't find what you're looking for?