For discussion of Speeduino compatible boards designed / built by other members of the forum and for guidance around making such a board
#33099
Yes, two regulators 5V needed. One for internal suply, one for external. This idea was tested in 722.6 controller. Short circuit on external 5V not reset Teensy (what is important). Teensy and all internal electronic work prop. even short circuit happend.

Add jumpers on IGN5, IGN6, IGN7, IGN8. If these outputs are not used, simply remove jumpers and pins on external plug can be used for expansion board.
Attachments
top.png
top.png (111.64 KiB) Viewed 38923 times
schematic.png
schematic.png (463.55 KiB) Viewed 38923 times
bottom.png
bottom.png (82.13 KiB) Viewed 38923 times
all.png
all.png (550.14 KiB) Viewed 38923 times
#33122
ok!
-Try to clean a bit, especially to avoid voids into the ground copper in the middle of the board (move some traces to have more gnd copper)
- try to have ground traces between each noisy sig.
- take care of the isolation from GND and some high voltage/high current signals (eg. INJ) It seems you just have 0.2mm or something.
-add vias everywhere you can into the ground plane, for a better grounding.
;)
#33131
I really like -┈▕▔╲
this project ┈┈▏▕
┈┈┈┈┈┈┈▏▕▂▂▂
▂▂▂▂▂▂╱┈▕▂▂▂▏
▉▉▉▉▉┈┈┈▕▂▂▂▏
▉▉▉▉▉┈┈┈▕▂▂▂▏
▔▔▔▔▔▔╲▂▕▂▂▂I

I
#33143
Today I start to build test platform (for home use) with all nececery hardware. Installed today: 4 injectors, TPS, stepper motor, fuel pump. Waiting for ignition coils.
Attachments
IMG_20190328_155203.jpg
IMG_20190328_155203.jpg (569.19 KiB) Viewed 38821 times
IMG_20190328_155144.jpg
IMG_20190328_155144.jpg (708.45 KiB) Viewed 38821 times
#33190
[quote]

RE: SPEEDUINO + TEENSY 3.5 - ECUTEEN3.5 - 8INJ/8IGN/CAN ETC.
by dvjcodec » Thu Mar 28, 2019 8:32 pm
Today I start to build test platform (for home use) with all nececery hardware. Installed today: 4 injectors, TPS, stepper motor, fuel pump. Waiting for ignition coils./quote]

And yet, no one to share the testing with you... :)
  • 1
  • 13
  • 14
  • 15
  • 16
  • 17
  • 25

Hi, I am trying to assign Signed values to the x-a[…]

Vr Conditioner Noise when cranking

New version 202305 don't fix the issue. Now after[…]

blitzbox

I've finally figured out why MAP and Lambda weren'[…]

Hello, I bring news!! Let me tell you that after […]

Still can't find what you're looking for?