[lyndonevans]

Hi Playmates

I ran a test on a BMW E36 Hall Effect sensor and thought I might share the results.

https://youtu.be/dF0HOpctG4M

Enjoy

[PSIG]

That's a good setup for testing a trigger wheel and sensor distance. If you just want to check function, whether on the vehicle or on the bench, just apply power and connect an LED and resistor from the +V wire to the sensor signal pin. Most automotive Hall sensors are open-collector or open-drain, so it will light the LED when something ferrous (wheel tooth, wrench, etc) comes near.

David

Simple connection often by back-probing the connector terminals (no soldering) with an LED and resistor:

Hall Function Test LED.jpg (16.85 KiB) Viewed 10871 times