Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For anything you'd like to see added to Speeduino
By andymcg
#24982
Has there been any progression on this? I am looking to use speeduino for my k series. is it possible to run using standard sensor and flywheel rather than fitting a 36-1 wheel? I have the 0.4.3 board with vr conditioner
By dazq
#24983
Not heard anything :-( perhaps you could put in another request on git for the feature!
By Dziku
#45712
Any progres? Is it posible to run vvc with vvt output? Theoreticaly it should work if we add cam trigger, and know the specs of the valve...
By miker
#45737
I'm going to have a watch of the video on making trigger patters again. If it makes sense I may have a play.
By dazq
#45739
Have a search on the Facebook group.
Someone did write a working mems decoder a while back but never submitted a pr for it via GitHub.
It may save some time rather than starting from scratch.
No synchronize

Maybe your VR conditioner has failed on one channe[…]

LED's 5,6,7,8 on all the time

Yeah, grounded Ardu-Stim to pin 10 on the 40 way I[…]

2CV 602 flat twin

Is it the 123 with the MAP feature? What engine ma[…]

PCB for Electromotive Tec3r

What do you think about this BM2LC120FJ-C for re[…]

Still can't find what you're looking for?