For any pieces of hardware directly related to Speeduino (ie Boards, components etc)
#22912
Dalenutbrown wrote: Wed Dec 06, 2017 9:49 pm Thank you for the assistance in figuring out what to get.
now I just need to figure out weather or not to use the tfi or to get/make an ignitor.
Dale
Not to break a thread again :roll: but just a note that running stock TFI is almost resolved, and testing will occur on a running engine shortly. I have a wiring diagram and settings created, but will wait to release it when confirmed, and any little notes and procedures are added. This simple setup will add one more to several options for using TFI to choose from.
:)
David
  • 1
  • 2
  • 3
  • 4
  • 5
  • 7
Injected 2 stroke Bultaco

Alternator testing. Its a 3 phase circa 200w alter[…]

BMW E23 M30B28

Okay, I managed to start the engine. The &quot[…]

NO2C crank signal issues

Once again PSIG, thank you. Note this is set up fo[…]

I've managed to dig up a few obscure wiring diag[…]

Still can't find what you're looking for?