For anything you'd like to see added to Speeduino
#21604
Hi i am looking to set this up on 2 different engines a 1JZ and a 1G engine both use primary and secondary trigger wheels, Primary is 36 with 2 missing teeth and the 1JZ has a 3 tooth cam signal to start the sequence for the 2 revolutions. The 1G has a similar setup.

I have looked at the dual wheel and the single wheel and cant seem to enable primary with missing teeth with a secondary cam signal?

Cheers
#21616
You want to use the missing tooth pattern, set as 36-2. In your case you don't actually need the cam signal at all as there's not sequential support for 6 cylinders anyway. The 36-2 will be all you need for a semi-sequential setup
By miker
#61345
Appreciate its not relevant for this specific instance but for reference, i've developed and got someone testing the toyota 3 pin cam on the v8 engine (and 2 pin exhaust cam).

I've also added code to (hopefully) support the 4 cylinder engine.
Running a k24a2 w/o a chassis

Good point! I guess for starters, is there a trigg[…]

Have you tried Missing Tooth (crank) as a 2-1 wh[…]

BMW E23 M30B28

The issue got worse recently. From the logs I can […]

Cool. 8-) Yes, it's actually simple to do basic[…]

Still can't find what you're looking for?