For discussion of anything related to the Speeduino documentation wiki
User avatar
By crazyafrican
#12673
In the Physical Layout section, both pin 2 and pin 39 are labeled "Injector 2 - Pin 2/2".

Not a big deal but might confuse some noobs
Last edited by crazyafrican on Wed Sep 14, 2016 8:34 pm, edited 1 time in total.
User avatar
By cx500tc
#12675
Note that is not limited to only Injector 2: all injectors connect to two pins on the connector.
This is by design so as to share current across multiple pins and not over load a single pin.
User avatar
By cx500tc
#12685
crazyafrican wrote:Yea, either one just needs to be labeled pin 1/2. Currently there is no pin 1/2 for injector 2
Unless I'm missing things, Injector 1 is 1/40; 2 is 2/39; 3 is 3/4; 4 is 5/6.
User avatar
By crazyafrican
#12693
You are correct. But look at pin 2 and pin 39, they are both labeled as "Injector 2 - Pin 2/2". There is no "Injector 2 - Pin 1/2". It's just a simple spelling mistake
dasd.png
dasd.png (40.23 KiB) Viewed 6156 times
Edit: Thanks PSIG :D

Hi, I am trying to assign Signed values to the x-a[…]

Vr Conditioner Noise when cranking

New version 202305 don't fix the issue. Now after[…]

blitzbox

I've finally figured out why MAP and Lambda weren'[…]

Hello, I bring news!! Let me tell you that after […]

Still can't find what you're looking for?