- Fri Oct 09, 2020 1:33 pm
#45749
Hello,
I've been trying to get wifi connectivity to work and have identified a few bits of the wiki that could be clearer in second serial in my view. This is based around the following bit of the wiki,
b) I thought the data stream for serial3 was a complete copy of the tuner studio datam, as implied by the quoted section above. I've been informed its not in this discussion thread, viewtopic.php?f=17&t=4253
It would also be good if the description on how to enable second serial was clearer with the menus required. Happy to have a go at writing instructions if required.
Cheers, Mike
I've been trying to get wifi connectivity to work and have identified a few bits of the wiki that could be clearer in second serial in my view. This is based around the following bit of the wiki,
A Simple Serial Porta) its not clear that tuner studio can only connect via serial0 / usb. I was expecting the data stream on serial 3 (arduino mega) to work with tuner studio.
A Serial port offers ,
Retrieve the current realtime data in full from Speeduino . This is the same data as sent to TunerStudio.
b) I thought the data stream for serial3 was a complete copy of the tuner studio datam, as implied by the quoted section above. I've been informed its not in this discussion thread, viewtopic.php?f=17&t=4253
It would also be good if the description on how to enable second serial was clearer with the menus required. Happy to have a go at writing instructions if required.
Cheers, Mike