- Thu May 27, 2021 1:42 pm
#50585
Hello all,
I recently picked up a Detonation EMS 1.3 for a project and wanted a 3D Printed enclosure for it so created one in tinkercad. It is a work in progress so I don't have holes for vents or heatsink as Im not sure how much heatsinking or ventilation it will need at this moment if I use high-Z injectors and logic level coils.
Here is a link to the design if you would like to modify it. https://www.tinkercad.com/things/gA6JZg ... R5hHtWSGwA
Attached is a STL file for printing as-is.
I printed mine in ABS for temp resistance. I added blocks in the inside to allow the end plates to be screwed on though the one corner of the Screw Terminal end plate doesnt have room for a fastener so I bonded that entire end plate on with acetone.
I'll upload some pics in a bit.
Brian
I recently picked up a Detonation EMS 1.3 for a project and wanted a 3D Printed enclosure for it so created one in tinkercad. It is a work in progress so I don't have holes for vents or heatsink as Im not sure how much heatsinking or ventilation it will need at this moment if I use high-Z injectors and logic level coils.
Here is a link to the design if you would like to modify it. https://www.tinkercad.com/things/gA6JZg ... R5hHtWSGwA
Attached is a STL file for printing as-is.
I printed mine in ABS for temp resistance. I added blocks in the inside to allow the end plates to be screwed on though the one corner of the Screw Terminal end plate doesnt have room for a fastener so I bonded that entire end plate on with acetone.
I'll upload some pics in a bit.
Brian
Attachments
(7.28 KiB) Downloaded 410 times
If the case-end is the same dimensions as the Hammond v0.4 cases, you can just screw 
- By hoopstar