For anything not related to Speeduino, but still about car/bike/boat/engines etc
#50585
Hello all,

I recently picked up a Detonation EMS 1.3 for a project and wanted a 3D Printed enclosure for it so created one in tinkercad. It is a work in progress so I don't have holes for vents or heatsink as Im not sure how much heatsinking or ventilation it will need at this moment if I use high-Z injectors and logic level coils.

Here is a link to the design if you would like to modify it. https://www.tinkercad.com/things/gA6JZg ... R5hHtWSGwA

Attached is a STL file for printing as-is.

I printed mine in ABS for temp resistance. I added blocks in the inside to allow the end plates to be screwed on though the one corner of the Screw Terminal end plate doesnt have room for a fastener so I bonded that entire end plate on with acetone.

I'll upload some pics in a bit.

Brian
Attachments
(7.28 KiB) Downloaded 406 times

Hi, I am trying to assign Signed values to the x-a[…]

Vr Conditioner Noise when cranking

New version 202305 don't fix the issue. Now after[…]

blitzbox

I've finally figured out why MAP and Lambda weren'[…]

Hello, I bring news!! Let me tell you that after […]

Still can't find what you're looking for?