- Tue Feb 25, 2020 1:17 am
#41137
Hi to all,
I was running a MS-2 on my bug since 2012 then decided to run a UA4C unit. I installed the wiring and all but I don't understand what setting goes in the trigger where it states degree ATDC. MS-2 has 80 on that spot.
I am running wasted spark. I attached a pic of my pulley config where my sensor sits at the #9 tooth. So, I want to know what degree number goes there since I tried: 80, 132, 347 and a few more without any success.
Thank you in advance.
I was running a MS-2 on my bug since 2012 then decided to run a UA4C unit. I installed the wiring and all but I don't understand what setting goes in the trigger where it states degree ATDC. MS-2 has 80 on that spot.
I am running wasted spark. I attached a pic of my pulley config where my sensor sits at the #9 tooth. So, I want to know what degree number goes there since I tried: 80, 132, 347 and a few more without any success.
Thank you in advance.
Attachments
Crank sensor
crank1.jpg (55.85 KiB) Viewed 5823 times
crank1.jpg (55.85 KiB) Viewed 5823 times
UA4C
(58.26 KiB) Downloaded 309 times
(58.26 KiB) Downloaded 309 times