Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For anything not related to Speeduino, but still about car/bike/boat/engines etc
By JHolland
#39243
Check the supply voltages are present using the programmer software. Is the board powered or are you trying to power it through the PICKit3?
User avatar
By Bleeker
#39329
I tried programming in circuit and also on a bread board.
Played around with all different kinds of settings, but nothing helped.

In the Video above the guy says it should show serial no. “default_pk3” for PICkit clones, but in my case it actually shows a serial no. not sure if this makes a difference.

I spend a lot of time googling this issue and it seems like the PICkit3 causes much more issues than the Version 2 but I found no solution for my problem.

When I measure the voltage directly on the PIC, should it always show some voltage when the PICkit is connected or just during programming?

Currently I´m thinking about buying a PICkit2 or just stop wasting my time and scrap that stuff ;)

Can you post a toothlog ? I have 944 and it uses […]

Modified 3 cylinder

My grandson is taking electrical engineering a[…]

In my experience the problem only usually occurs[…]

3rz-fe turbo. help with iac valve

READ THE WIKI. https://wiki.speeduino.com/en/conf[…]

Still can't find what you're looking for?