- Sat May 15, 2021 9:32 am
#50340
I am planning to use this Molex 560045-1201 CMX connector for my ECU design. Is it possible to wire it on a double layer PCB? I have also attached the datasheet. The pitch is 2.5mm for signal pins which makes it difficult to route the tracks upto connector pins as they are tightly packed.
Attachments
IMG_20210515_144249.jpg (6.06 MiB) Viewed 11188 times
IMG_20210515_144258.jpg (5.6 MiB) Viewed 11188 times
IMG_20210515_144308.jpg (5.21 MiB) Viewed 11188 times
(523.29 KiB) Downloaded 777 times