Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For any other general hardware. Can be OEM parts (Eg Coils, injectors etc) or anything more specific.
By Devinder Singh
I am planning to use this Molex 560045-1201 CMX connector for my ECU design. Is it possible to wire it on a double layer PCB? I have also attached the datasheet. The pitch is 2.5mm for signal pins which makes it difficult to route the tracks upto connector pins as they are tightly packed.
IMG_20210515_144249.jpg (6.06 MiB) Viewed 3434 times
IMG_20210515_144258.jpg (5.6 MiB) Viewed 3434 times
IMG_20210515_144308.jpg (5.21 MiB) Viewed 3434 times
(523.29 KiB) Downloaded 187 times
By SilentBob
What mcu are you using? 120 pins is probably way more than you'll need. Maybe look for a connector with a lower pin count and wider spacing if it's a concern

Eeprom-clear? Its a "firmware" you can[…]

No its the 6 pin connector at the left slck, mosi[…]

No there are no "official " interface bo[…]

EVAP purge programming

AFR target >14 and RPM <4000 was my first ro[…]

Still can't find what you're looking for?