Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For any pieces of hardware directly related to Speeduino (ie Boards, components etc)
By Vitoos
#45454
i have esp32 wroom module, i tried various ways to connect it to speeduino but i can't configure it with at commands. on the module I have the espressif 2.0 firmware, does anyone know how to do it ??
By Sunglasses
#46986
I have had success with the ESP-Link firmware on ESP8266, but I cannot say if it works for ESP32. But perhaps this could be a starting point.

Wrong forum section, BTW ;)

Eeprom-clear? Its a "firmware" you can[…]

No its the 6 pin connector at the left slck, mosi[…]

No there are no "official " interface bo[…]

EVAP purge programming

AFR target >14 and RPM <4000 was my first ro[…]

Still can't find what you're looking for?