For any discussion not specifically related to your project
By sinatrablue
#67369
im setting up a b18c1 in a 1990 crx for a friend of mine. i built a v0.4 board and im using it in conjuction with the ss-obd1 adapter from wtmtronics.

My friend purchased an additional distributor off ebay for me to modify the crank/cam trigger wheels but this is seeming to be difficult to properly setup since the crank and cam are both 1/2 of crank speed.

Im considering cutting 2 teeth off on the 24t wheel to turn it into two 12-1 wheels for the crankshaft sensor input, and using poll level on the "snail" single tooth.

Any other suggestions on this?

Bro, just put speed to take care of all fuel and i[…]

No worries. Life gets in the way. A lot. See yo[…]

STM32 development

So here's a little update on the subject of my pas[…]

NO2C crank signal issues

Also sometimes when i turn the ECU off it seems to[…]

Still can't find what you're looking for?