For any discussion not specifically related to your project
By Welp
#58145
Hello Everyone,

Does anybody know how to test for injector open time? Because, I've seen megasquirt users done this getting their injector open time.

Thank you.
User avatar
By PSIG
#58151
Do some searching for previous info and examples of bench-testing with an oscilloscope or by timed pulses vs flow volume; or run-testing on the engine using either manual O2 correction or by calculation, etc. Injector latency is important at low PW, and a common source of tuning frustration, so pick your method and go for it. You can also find various articles online for ways to get a good set of numbers for latency (dead-time, lag, open-time, etc).
By Welp
#58154
PSIG you're a freaking GOAT when it comes to Speeduino. I never had the chance to thank you enough. So, Thank you for being an active member of this forum and also being so Freaking smart!

It looks like you have a fuel supply issue. readin[…]

Will this have an updated version about this featu[…]

Vr Conditioner Noise when cranking

I did the fix, but it's not work. I put my setti[…]

Perhaps some different points and pictures. Instr[…]

Still can't find what you're looking for?