For any discussion not specifically related to your project
#57647
update-
the problem was the tps threshold
the tps threshold was 127 percent so i change it to 3 and its work perfect

**********************************************************************8
hello

I have mitsubishi pajero with 1uz swap with v0.3 and everything works excellent, except one thing I can't solve,
the launch control.
-the pin number is 51
-low
-pullup
when I ground pin number 51 nothing changed
do i need to solder the resistor for the pullup?
Last edited by ofireg98 on Thu Jul 07, 2022 12:20 pm, edited 2 times in total.

It looks like you have a fuel supply issue. readin[…]

Will this have an updated version about this featu[…]

Vr Conditioner Noise when cranking

I did the fix, but it's not work. I put my setti[…]

Perhaps some different points and pictures. Instr[…]

Still can't find what you're looking for?